Rohde & Schwarz MXO 4 Series - Using a Frequency Response Analysis; Settings for Frequency Response Analysis

ApplicationsMXO 4 Series
259User Manual 1335.5337.02 ─ 07
Vertical position and size of the waveforms
To set the position and the vertical scaling of the gain, phase or amplitude waveforms,
select the waveform and use the vertical [Scale] and [Position] (upper knob) knobs.
The remote commands for setting the position and scales of the are described in
Chapter 17.15.1.4, "Frequency response analysis diagram settings", on page 668.
11.1.2 Using a frequency response analysis
Connecting the test setup
To avoid measurement uncertainties, make sure that the cables connecting the input
and the output of your DUT to the oscilloscope are of similar length.
Starting the FRA
1.
Press the
[Apps] key.
2. In the "General" tab, tap "FRA".
The FRA window opens. Only the settings relevant for the FRA setup are visible in
the "Menu".
Closing the FRA
► Tap the "Exit FRA" key at the bottom-right corner of the display.
11.1.3 Settings for frequency response analysis
The following chapters, describes the settings that you can define for the frequency
response analysis.
11.1.3.1 Setup
Access: [Apps] > "General" > "FRA" > "Setup".
Frequency response analysis (option R&S
MXO4-K36)