Rohde & Schwarz MXO 4 Series - Page 265

ApplicationsMXO 4 Series
265User Manual 1335.5337.02 ─ 07
Auto scale
If enabled, the vertical scaling of input and output channel is done automatically for
every new measurement frequency point.
That guarantees a non-disturbed signal and a maximum of measurement resolution.
For Coupling = "DC", the channel offset is also changed to compensate the signal off-
set.
Remote command:
FRANalysis:AUToscale on page 661
11.1.3.4 Display
Access: [Apps] > "General" > "FRA" > "Display".
In this dialog, you can select which elements are displayed in the FRA diagram.
Display points
Enables the display of the measurement points for the frequency response analysis.
Remote command:
FRANalysis:MEASurement:POINt[:DISPlay] on page 664
Result table
Enables the display of the result table for the FRA.
Remote command:
FRANalysis:RESult:STATe on page 672
Markers
Enables the display of the marker table for the FRA.
Remote command:
FRANalysis:MARKer<m>:STATe on page 673
Margin
Enables the display of the margin table for the FRA.
Remote command:
FRANalysis:MARGin:STATe on page 672
Frequency response analysis (option R&S
MXO4-K36)