Getting StartedMXO 4 Series
28User Manual 1335.5337.02 ─ 07
3 Getting Started
3.1 Preparing for use
Here, you can find basic information about setting up the instrument for the first time or
when changing the operating site.
3.1.1 Lifting and carrying
See: "Lifting and carrying the instrument" on page 18.
3.1.2 Unpacking and checking
1. Unpack the product carefully.
2. Retain the original packing material. Use it when transporting or shipping the prod-
uct later.
3. Using the delivery notes, check the equipment for completeness.
4. Check the equipment for damage.
If the delivery is incomplete or equipment is damaged, contact Rohde & Schwarz.
3.1.3 Choosing the operating site
Specific operating conditions ensure proper operation and avoid damage to the prod-
uct and connected devices. For information on environmental conditions such as ambi-
ent temperature and humidity, see the specifications document.
For safety information, see "Choosing the operating site" on page 18.
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate the
product. The EMC class of the product is given in the specifications document.
●
Class B equipment is suitable for use in:
– Residential environments
– Environments that are directly connected to a low-voltage supply network that
supplies residential buildings
●
Class A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and radi-
ated disturbances. It is therefore not suitable for class B environments.
Preparing for use
To Next Page
Loading...
