Rohde & Schwarz MXO 4 Series - Waveform Generator Saveset

Data and file managementMXO 4 Series
295User Manual 1335.5337.02 ─ 07
To load settings from a saveset file
1. Open "Menu" > "Save/Recall".
2. In the "Recall" tab, press the "Saveset" button.
The recall "Saveset" dialog opens.
Figure 12-4: Recall saveset dialog
3. Tap "Open".
4. Navigate to the required saveset.
The saved settings are loaded to the MXO 4.
Remote commands:
●
MMEMory:SAV on page 604
●
MMEMory:RCL on page 604
12.1.2 Waveform generator saveset
Generator savesets store the instruments generator configuration.
To save settings to a saveset file
1. Open "Menu" > "Save/Recall".
2. In the "Save" tab, press the "Gen saveset" button.
The save "Gen saveset" dialog opens.
Save and recall user settings