Data and file managementMXO 4 Series
305User Manual 1335.5337.02 ─ 07
Value Description
Range Range of the signal in y-direction
Offset Center of the y-range
Resolution Resolution of the y-axis
IsLogarithmic Indicates if the y-axis is logarithmic (ON or OFF)
PostProcessingSampleFormatAttributes
ValueStorage Interpretation of the data: is INTEGER or FLOAT (floating point data)
ValueInterpretation Indicates if the data is saved as binary ADC values (BINARY), or
physical values (PHYSICAL)
SampleBitSize Value size in bit, as used in processing
ValueBitSize Value size of ADC data in bit
LsbExtensionBits Number of bits the ADC value is shifted to the left in the CPU sample
size
AdcValueBitSize Number of bits of the ADC that was used to sample the signal. It
does not include any additionally gained bits due to high definition
mode.
IsSigned Signed values (ON) or unsigned values (OFF)
PostProcessingBufferSampleCounts
[DeltaPreSamples | PreSamples ||
PostSamples | DeltaPostSamples]
Indicates the distribution of the samples. || marks the trigger time.
The sum of PreSamples and PostSamples matches the requested
record length. DeltaSamples are additional samples that needed for
computation but they are not measured or displayed.
Note: FractionalBits was removed in FW version 1.3.x. Reference waveforms created
with older FW version are compatible and can be reloaded.
12.3 Saving results
In this tab, you can select the result tables to be saved, and define the storage set-
tings.
Saving results
To Next Page
Loading...
