Protocol analysisMXO 4 Series
333User Manual 1335.5337.02 ─ 07
12. Set the logical thresholds:
a) Tap the "Thresholds" tab.
b) For each wire, set the threshold value. A typical value is 1.65 V.
c) If necessary, set the hysteresis value for the wires.
d) Optionally, tap on "Show threshold lines".
13.2.6.2 Triggering on SPI
Prerequisites: A bus is configured for the SPI signal to be analyzed. See Chap-
ter 13.2.6.1, "Configuring SPI signals", on page 331.
For details on configuration settings, see Chapter 13.2.2, "SPI configuration",
on page 322.
SPI bus (option R&S
MXO4-K510)
To Next Page
Loading...
