Getting StartedMXO 4 Series
34User Manual 1335.5337.02 ─ 07
To disconnect from power
The product is in the standby state.
1.
NOTICE! Risk of data loss. If you disconnect the product from power when it is in
the ready state, you can lose settings and data. Shut it down first.
Set the switch on the power supply to position [0].
The LED of the [Power] key is switched off.
2. Disconnect the product from the power source.
3.2 Instrument tour
This section describes the front, rear and side view of the instrument including all func-
tion keys and connectors.
3.2.1 Front view
This section provides an overview of the MXO 4 front panel.
Instrument tour
To Next Page
Loading...
