Rohde & Schwarz MXO 4 Series - Page 342

Protocol analysisMXO 4 Series
342User Manual 1335.5337.02 ─ 07
In the "Filter" tab, you can define the settings to display only the frames that match the
selected filter conditions.
Check all, Clear, Invert, Reset
The following settings help you select the frames and errors you want to filter for. Only
the frames and error types that match the selected filter conditions are displayed.
"Check all"
Enables the filter for all available frames and error types.
"Clear"
Disables the filter for all available frames and error types.
"Invert"
Inverts the current state of the frame and error types: all frames and
error types that were enabled are disabled and vice versa.
"Reset"
Resets the state of the selected frames and error types.
Remote command:
SBUS<sb>:I2C:FILTer:CHKall on page 733
SBUS<sb>:I2C:FILTer:CLR on page 734
SBUS<sb>:I2C:FILTer:INVert on page 734
SBUS<sb>:I2C:FILTer:RST on page 734
Frame type
Selects the frame type that you want to display. You can filter all enabled frame types
simultaneously.
I²C (option R&S
MXO4-K510)