Protocol analysisMXO 4 Series
356User Manual 1335.5337.02 ─ 07
Protocol type
Displays the protocol type to be decoded.
Remote command:
SBUS<sb>:TYPE on page 704
State
Enables the decoding of the selected bus. The signal icon of the bus appears on the
signal bar.
Source: Tx, Rx
Select the input channels for the transmitter and receiver signals.
Do not combine a reference waveform with channel or math waveform because the
time correlation of these waveforms might differ.
Remote command:
SBUS<sb>:UART:TX:SOURce on page 751
SBUS<sb>:UART:RX:SOURce on page 749
UART (option R&S
MXO4-K510)
To Next Page
Loading...
