Rohde & Schwarz MXO 4 Series - Page 360

Protocol analysisMXO 4 Series
360User Manual 1335.5337.02 ─ 07
Check all, Clear, Invert, Reset
The following settings help you select the frames and errors you want to filter for. Only
the frames and error types that match the selected filter conditions are displayed.
"Check all"
Enables the filter for all available frames and error types.
"Clear"
Disables the filter for all available frames and error types.
"Invert"
Inverts the current state of the frame and error types: all frames and
error types that were enabled are disabled and vice versa.
"Reset"
Resets the state of the selected frames and error types.
Remote command:
SBUS<sb>:UART:FILTer:CHKall on page 755
SBUS<sb>:UART:FILTer:CLR on page 755
SBUS<sb>:UART:FILTer:INVert on page 755
SBUS<sb>:UART:FILTer:RST on page 755
Frame type
Selects the frame type that you want to display. You can filter all enabled frame types
simultaneously.
For each frame type, you can also specify conditions for the value of the fields in the
"Edit" dialog.
The available frames are "Tx", "Rx".
Remote command:
SBUS<sb>:UART:FILTer:FRAMe<fr>:ENABle on page 758
SBUS<sb>:UART:FILTer:FRENable on page 758
Edit
Opens a dialog to define the details of the selected frame.
UART (option R&S MXO4-K510)