Rohde & Schwarz MXO 4 Series - Page 383

Protocol analysisMXO 4 Series
383User Manual 1335.5337.02 ─ 07
Remote command:
TRIGger:CAN:DLC on page 770
TRIGger:CAN:DLCCondition on page 770
Data pattern
Specifies the data pattern.
"Condition"
Sets the comparison condition to a specific value or a range.
"Value"
Specifies the value or sets the start value of a range.
Remote command:
TRIGger:CAN:DCONdition on page 769
TRIGger:CAN:DMIN on page 769
ID type
Selects the length of the identifier:
"11 bit"
Identifier length of the CAN base frame format. The instrument trig-
gers on the sample point of the identifier extension flag (IDE) bit.
"29 bit"
Identifier length of the CAN extended frame format. The instrument
triggers on the sample point of the remote transmission request
(RTR) bit.
"Any"
The ID type and ID pattern are not relevant for the trigger condition.
If the trigger type is "Identifier", the instrument triggers on any identi-
fier in the specified frame type.
If the trigger type is "Identifier + Data", set the "ID type" to "Any" if you
want to trigger only on data.
Remote command:
TRIGger:CAN:ITYPe on page 772
BRS, ESI
If "Frame type" = "FBFF"/"FEFF", you can trigger on specific bits.
"BRS"
The bit rate switch bit. Value 1 means that the bit rate switches from
the arbitration rate to the faster data rate.
"ESI"
The error state indicator bit. Set "X" if the bit is not relevant.
Remote command:
TRIGger:CAN:FDATa:BRS on page 773
TRIGger:CAN:FDATa:ESI on page 774
SDT
Specifies a value or a range for the service data unit type.
"Condition"
Sets the comparison condition to a specific value or a range.
"Value"/"From"
Specifies the value or sets the start value of a range.
"To"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
CAN (option R&S MXO4-K520)