Protocol analysisMXO 4 Series
403User Manual 1335.5337.02 ─ 07
The "Export results" dialog opens.
For details, see Chapter 13.1.7, "Export protocol results", on page 318.
2. Select the details that you want to export and the file format.
3. Tap "Save as".
4. Key in a name and select the file format.
Remote commands
Remote commands to retrieve decode results are described in Chapter 17.16.6, "LIN
(option R&S MXO4-K520)", on page 795.
13.6.5 Performing LIN decoding
This chapter explains step by step how to configure and decode the LIN bus.
13.6.5.1 Configuring LIN signals
For configuration, assign the lines to the input channels, and define the active states
and the logical thresholds.
For details on configuration settings, see Chapter 13.6.1, "LIN configuration",
on page 394.
1. Tap the "Bus" activator in the bottom right of the screen.
2. Select the tab of the bus that you want to set up, for example "SB1".
3. Tap the "Protocol type" button. Select the protocol: LIN.
4. Tap on "State" to enable the decoding.
An SPI shortcut appears at the bottom left of the screen. Tap on the shortcut for a
quick access to the "LIN" dialog settings.
5. Select the "LIN standard".
6. Select the correct channel for "Data".
7. Set the "Bit rate".
8. Check that the signals are on the screen.
LIN (option R&S
MXO4-K520)
To Next Page
Loading...
