Rohde & Schwarz MXO 4 Series - Page 415

Protocol analysisMXO 4 Series
415User Manual 1335.5337.02 ─ 07
Remote command:
SBUS<sb>:TNOS:SOURce on page 828
13.8.1.2 Threshold settings
Access: [Apps] key > "Protocol" tab > "10Base -T1S" > "Thresholds".
Threshold
Sets the threshold for the data channel. Enter the value directly in the fields.
Additional to the threshold, you can also set a hysteresis.
Remote command:
SBUS<sb>:TNOS:THReshold:LOWer on page 829
SBUS<sb>:TNOS:THReshold:UPPer on page 829
SBUS<sb>:TNOS:HYSTeresis on page 828
Show threshold lines
If enabled, the threshold lines are displayed in the diagram.
The label of the threshold line is set according to the signal that it is referring to, see
also Show threshold lines.
Remote command:
SBUS<m>:THReshold on page 705
13.8.1.3 Display settings
For details about the display settings, see Chapter 13.1.4, "Display", on page 315.
Decode layer
Selects the decode layer.
10BASE-T1S (option R&S
MXO4-K560)