Rohde & Schwarz MXO 4 Series - 10 BASE-T1 S Decode Results

Protocol analysisMXO 4 Series
418User Manual 1335.5337.02 ─ 07
"Field"
Enables the field type that you want to filter on for the selected frame.
The available fields are "Dest", "Src", "Len/Type" and "Data".
Remote command:
SBUS<sb>:TNOS:FILTer:FIENable on page 833
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:ENABle
on page 833
"Condition"
Displays the value condition for the selected field.
Remote command:
SBUS<sb>:TNOS:FILTer:BIT on page 831
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:BIT
on page 831
"Data"
The data setup consists of a comparison condition and one or two
data patterns.
Remote command:
SBUS<sb>:TNOS:FILTer:DMAX on page 832
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:DMAX
on page 832
SBUS<sb>:TNOS:FILTer:DMIN on page 832
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:DMIN
on page 832
SBUS<sb>:TNOS:FILTer:DOPerator on page 832
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:DOPerator
on page 832
"Index"
The index setup consists of a comparison condition and one or two
index values.
Remote command:
SBUS<sb>:TNOS:FILTer:IMAX on page 833
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:IMAX
on page 833
SBUS<sb>:TNOS:FILTer:IMIN on page 834
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:IMIN
on page 834
SBUS<sb>:TNOS:FILTer:IOPerator on page 834
SBUS<sb>:TNOS:FILTer:FRAMe<fr>:FLD<fl>:IOPerator
on page 834
Error type
Enables filtering on the selected error type.
Remote command:
SBUS<sb>:TNOS:FILTer:ERENable on page 833
SBUS<sb>:TNOS:FILTer:ERRor<n>:ENABle on page 833
13.8.3 10BASE-T1S decode results
When the configuration of the serial bus is complete, the signal can be decoded:
10BASE-T1S (option R&S
MXO4-K560)