Rohde & Schwarz MXO 4 Series - Page 440

Waveform generator (option R&S MXO4-B6)MXO 4 Series
440User Manual 1335.5337.02 ─ 07
Frequency
Sets the frequency of the modulating waveform for AM/FM/PWM modulation.
Remote command:
WGENerator<wg>:MODulation:AM:FREQuency on page 864
WGENerator<wg>:MODulation:FM:FREQuency on page 866
WGENerator<wg>:MODulation:PWM:FREQuency on page 869
Depth
Sets the modulation depth, the percentage of the amplitude range that is used for AM
modulation.
Remote command:
WGENerator<wg>:MODulation:AM:DEPTh on page 863
Duty cycle
Sets the duty cycle for a square waveform. The duty cycle expresses for what percent-
age fraction of the period, the waveform is active, i.e. the signal state is high.
Remote command:
WGENerator<wg>:MODulation:AM:DCYCle on page 863
WGENerator<wg>:MODulation:FM:DCYCle on page 865
WGENerator<wg>:MODulation:PWM:DCYCle on page 868
Symmetry
Sets the symmetry for the ramp modulation waveform, the percentage of time that the
waveform is rising.
Remote command:
WGENerator<wg>:MODulation:AM:SYMMetry on page 864
WGENerator<wg>:MODulation:FM:SYMMetry on page 866
WGENerator<wg>:MODulation:PWM:SYMMetry on page 869
Deviation
Sets the frequency deviation, the maximum difference between the FM modulated sig-
nal and the carrier signal.
Remote command:
WGENerator<wg>:MODulation:FM:DEViation on page 865
Modulation depth
Sets the modulation depth, the percentage of the amplitude range that is used for
PWM modulation.
Remote command:
WGENerator<wg>:MODulation:PWM:DEPTh on page 869
Frequency 1/Frequency 2
Sets the frequency of the first /second signal in FSK modulated signal.
Remote command:
WGENerator<wg>:MODulation:FSK:FONE on page 867
WGENerator<wg>:MODulation:FSK:FTWO on page 867
Setup of the waveform generator