Getting StartedMXO 4 Series
45User Manual 1335.5337.02 ─ 07
3.2.4.6 Analysis keys
The controls in the bottom functional block have various functions.
[Multiuse]
The multiuse knob changes the element that is in focus. It lights up when a function is
active on the knob.
●
If a numeric entry field in a dialog has the focus: turn to increase or decrease the
value.
●
If a cursor set has the focus: press to toggle the cursor line, and turn to adjust its
position.
●
If a zoom has the focus: press to toggle the edges of the zoom, and turn to adjust
its position.
●
If a gate has the focus: press to toggle the complete gate and the edges of the
gate, and turn to adjust its position.
●
To change the intensity, press the [Intensity] key and turn the knob.
[Intensity]
Adjusts the intensity of the waveforms on the screen: Press the [Intensity] key and turn
the [Multiuse] knob. The current value is shown in the input box in the upper right cor-
ner of the screen.
[Cursor]
Starts a cursor measurement: sets vertical and horizontal cursors in the active dia-
gram, and displays results of the cursor measurement. If cursors are already set, the
keypress opens the "Cursor" dialog, where you can adjust the settings. The next key-
press closes the dialog.
Cursors are markers which are placed at points of interest on a waveform. The instru-
ment measures the cursor positions and delta values between parallel cursors.
If cursors are already set but not in focus, pressing the key sets the focus on the cursor
set. You can adjust the cursor lines using the [Multiuse] knob.
If a cursor set has the focus, the key opens the "Cursor" dialog. If one cursor set is
"On", the next press closes the dialog. If several cursors are "On", pressing the key
toggles the cursor sets.
Instrument tour
To Next Page
Loading...
