Network operation and remote controlMXO 4 Series
459User Manual 1335.5337.02 ─ 07
6. Leave the "User name" and "Password" empty. Click "OK".
If there are problems with the connection, check if the "WebClient" service is running:
"Task Manager" > "Services" tab. If the "WebClient" service is not running, start it.
16.3 Remote operation with VNC client
If the MXO 4 is connected to a computer via LAN, you can operate the instrument from
the computer using a VNC client. Therefore, install a VNC client on the computer.
To operate the instrument via VNC client:
1. Start the VNC client.
2. Enter the hostname (device name) of the instrument. You find the name in the
instrument information on the oscilloscope. Tap the Rohde & Schwarz logo to show
the information.
3. Connect to the instrument.
You see the display of the oscilloscope and can use the menus, dialogs, SmartGrid
and all operating means of the display.
16.4 Remote control
Remote control automates the operation of the instrument using SCPI commands,
scripts and programs.
For general information on remote control of Rohde & Schwarz products via SCPI,
refer to www.rohde-schwarz.com/rc-via-scpi.
The following sections describe the instrument-specific basics of remote control. SCPI
commands are listed and described in chapter Chapter 17, "Remote control com-
mands", on page 472.
● Remote control interfaces and protocols...............................................................459
● Starting and stopping remote control.................................................................... 461
16.4.1 Remote control interfaces and protocols
The instrument supports different interfaces for remote control. The following table
gives an overview.
Remote control
To Next Page
Loading...
