Remote control commandsMXO 4 Series
477User Manual 1335.5337.02 ─ 07
//Turn on spectrum of C1.
//By default, the spectrum is set below its analog source, and into the next
//free diagram (here diagram 2).
CALC:SPEC:STAT 1
CALC:SPEC:FREQ:CENT 20e6
CALC:SPEC:FREQ:SPAN 4e6
CALC:SPEC:FREQ:SCAL 15
//Set C1 and spectrum side by side by changing the split type.
LAY2:NODE1:STYP HOR
//Add zoom to spectrum. The zoom is located in layout 2, in diagram 2.
LAY2:ZOOM:ENAB 1
LAY2:ZOOM:SOUR 2
Programming examples
To Next Page
Loading...
