Rohde & Schwarz MXO 4 Series - Page 48

Getting StartedMXO 4 Series
48User Manual 1335.5337.02 ─ 07
9. Turn the [Level] knob to set the trigger level to 300 mV.
10. Check the rectangle signal on the screen. The displayed signal should have an
amplitude of about 3.3 V, which covers 5.5 divisions.
11. Repeat steps 4 to 10 for all other channels. Make sure to adjust the vertical set-
tings for the connected channel, and also to set the trigger source to the connected
channel.
Instrument tour