Rohde & Schwarz MXO 4 Series - Toolbar

Remote control commandsMXO 4 Series
492User Manual 1335.5337.02 ─ 07
Parameters:
<Type> NONE | DIAG | DIAGRAM | RES | RESULT | NODE
DIAG = DIAGRAM, RES = RESULT
*RST: NONE
Example: See Chapter 17.4.1, "SmartGrid layout with zoom", on page 474.
Usage: Asynchronous command
LAYout<ly>:NODE<no>:RATio <SplitRatio>
Sets the size ratio of the two children in the specified node.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
<no> Index of the node
Parameters:
<SplitRatio> Size ratio of the children. 0.5 assigns 50% of the node size to
each child. 0.3 assigns 30% to child 1% and 70% to child 2.
Range: 0 to 1
Increment: 0.0001
*RST: 0.5
Usage: Asynchronous command
LAYout<ly>:NODE<no>:STYPe <SplitType>
Creates a second child (e.g. diagram) in the node if only one child exists, and sets the
splitting of the node. If two children exist, only the splitting is set.
Suffix:
<ly>
.
1...4, index of the SmartGrid layout
<no> Index of the node
Parameters:
<SplitType> HOR | HORIZONTAL | VERT | VERTICAL
HOR = HORIZONTAL, VERT = VERTICAL
*RST: NONE
Example: See Chapter 17.4.1, "SmartGrid layout with zoom", on page 474.
Usage: Asynchronous command
17.7.3 Toolbar
DISPlay:TOOLbar:COUNt?............................................................................................. 493
DISPlay:TOOLbar:DESelect............................................................................................493
DISPlay:TOOLbar:RESTore............................................................................................ 493
Instrument setup