Rohde & Schwarz MXO 4 Series - Page 501

Remote control commandsMXO 4 Series
501User Manual 1335.5337.02 ─ 07
17.7.5.5 Save/Recall
Autonaming
MMEMory:AUTonaming:PREFix...................................................................................... 501
MMEMory:AUTonaming:TIME......................................................................................... 501
MMEMory:AUTonaming:INDex........................................................................................ 501
MMEMory:AUSave:ENABle............................................................................................ 501
MMEMory:AUSave:INTerval............................................................................................501
MMEMory:AUTonaming:USERtext...................................................................................502
MMEMory:AUTonaming:DEFaultpath............................................................................... 502
MMEMory:AUTonaming:RESall....................................................................................... 502
MMEMory:AUTonaming:RESPath....................................................................................502
MMEMory:AUTonaming:TEXT.........................................................................................503
MMEMory:AUTonaming:PREFix <MainNmeStemSt>
MMEMory:AUTonaming:TIME <DateTime>
MMEMory:AUTonaming:INDex <NameIndex>
Includes or excludes the prefix/ date/time /index in the filename pattern for automatic
filename generation. This name is used as the default filename.
The prefix indicates the type of data that is saved, for example, RefCurve, Settings.
Parameters:
<NameIndex> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Index" on page 102
MMEMory:AUSave:ENABle <EnableAutosave>
Enables the automatic saving of the waveform. You can set the autosave interval with
MMEMory:AUSave:INTerval.
Parameters:
<EnableAutosave> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Enable autosave" on page 102
MMEMory:AUSave:INTerval <AutosaveIntvl>
Defines the time interval for the automatic saving of the waveform, if MMEMory:
AUSave:ENABle is set to ON.
Instrument setup