Rohde & Schwarz MXO 4 Series - Page 502

Remote control commandsMXO 4 Series
502User Manual 1335.5337.02 ─ 07
Parameters:
<AutosaveIntvl> Range: 1 to 360000
Increment: 1
*RST: 300
Default unit: s
Usage: Asynchronous command
Manual operation: See "Enable autosave" on page 102
MMEMory:AUTonaming:USERtext <NmeStringSt>
If enabled, inserts the specified user text after the prefix.
You can define the text with MMEMory:AUTonaming:TEXT.
Parameters:
<NmeStringSt> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "User text" on page 101
MMEMory:AUTonaming:DEFaultpath <Path>
Sets the path where data and settings files are stored. On the instrument, all user data
is written to /home/storage/userData. You can create subfolders in this folder.
Parameters:
<Path> String parameter
Usage: Asynchronous command
Manual operation: See "Default path for all file operations" on page 102
MMEMory:AUTonaming:RESall
Resets all autonaming settings to the default value, including the path.
Usage:
Setting only
Asynchronous command
Manual operation: See "Reset path" on page 102
MMEMory:AUTonaming:RESPath
Resets the path for file operations to the factory default path.
Usage:
Setting only
Asynchronous command
Manual operation: See "Reset path" on page 102
Instrument setup