Rohde & Schwarz MXO 4 Series - Page 518

Remote control commandsMXO 4 Series
518User Manual 1335.5337.02 ─ 07
Return values:
<ADCSampleRate> Range: 5 Gsample/s (interleaved), 2,5 Gsample/s (non-
interleaved)
Default unit: Hz
Usage: Query only
Asynchronous command
ACQuire:POINts:MAXimum <RecLengthLimit>
Sets the maximum record length, if ACQuire:POINts:MODE is set to AUTO.
Parameters:
<RecLengthLimit> Range: 1000 to 800E+6
Increment: 2
*RST: 10E+6
Default unit: pts
Usage: Asynchronous command
Manual operation: See "Record length limit" on page 113
ACQuire:POINts:MODE <RecLengthMode>
Selects the mode of the waveform record length adjustment.
The record length is the number of waveform samples that are stored in one waveform
record after processing, including interpolation. It determines the length of the dis-
played waveform.
Parameters:
<RecLengthMode> AUTO | MANual
AUTO
Record length is determined automatically and changes due to
instrument internal adjustments.
MANual
The waveform record length is defined with ACQuire:
POINts[:VALue].
*RST: AUTO
Usage: Asynchronous command
Manual operation: See "RL mode" on page 113
ACQuire:RESolution <Resolution>
Defines the time between two waveform samples in the waveform record. It considers
the processing of the captured samples including interpolation. A fine resolution with
low values produces a more precise waveform record.
The resolution is the reciprocal value of ACQuire:SRATe[:VALue].
Acquisition and setup