Rohde & Schwarz MXO 4 Series - Fast Segmentation

Remote control commandsMXO 4 Series
520User Manual 1335.5337.02 ─ 07
*RST: AUTO
Usage: Asynchronous command
Manual operation: See "SR mode" on page 112
ACQuire:SRReal <HWSampleRate>
Returns the sample rate of the waveform after HW processing. Interpolation is not con-
sidered.
Parameters:
<HWSampleRate> Range: Device specific to ADC sample rate
Increment: 0
*RST: Device specific
Default unit: Sa/s
Usage: Asynchronous command
ACQuire:TYPE <AcqMd>
Sets how the waveform is built from the captured samples.
Parameters:
<AcqMd> SAMPle | PDETect | ENVelope | AVERage
*RST: SAMPle
Usage: Asynchronous command
Manual operation: See "Acquisition mode" on page 114
17.8.7 Fast segmentation
ACQuire:SEGMented:STATe <State>
If fast segmentation is enabled, the acquisitions are performed as fast as possible,
without processing and displaying the waveforms. When acquisition has been stopped,
the data is processed and the latest waveform is displayed. Older waveforms are
stored in segments. You can display and analyze the segments using the history.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Fast segmentation" on page 116
Acquisition and setup