Rohde & Schwarz MXO 4 Series - Page 528

Remote control commandsMXO 4 Series
528User Manual 1335.5337.02 ─ 07
PROBe<ch>:SETup:ZAXV <AttenuationZA15>
If you use the external attenuator R&S RT-ZA15 together with one of the differential
active probes R&S RT-ZD10/20/30, enable "RT-ZA15 attenuator" to include the exter-
nal attenuation in the measurements.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<AttenuationZA15> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "RT-ZA15 attenuator" on page 132
PROBe<ch>:PMETer:STATe <State>
Activates the integrated R&S ProbeMeter on probes with Rohde & Schwarz probe
interface.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "ProbeMeter" on page 130
PROBe<ch>:PMETer:RESults:SINGle?
Returns the R&S ProbeMeter measurement result of single-ended active
Rohde & Schwarz probes, the voltage measured between the probe tip and the
ground.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Return values:
<Result> Range: -1E+26 to 1E+26
Increment: 0.001
*RST: 0
Default unit: V
Usage: Query only
Asynchronous command
Manual operation: See "ProbeMeter" on page 130
Acquisition and setup