Rohde & Schwarz MXO 4 Series - Page 531

Remote control commandsMXO 4 Series
531User Manual 1335.5337.02 ─ 07
Manual operation: See "Bandwidth limit" on page 135
PROBe<ch>:SETup:ADVanced:RANGe <ProbeRange>
Sets the voltage range of an R&S RT-ZHD probe.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<ProbeRange> AUTO | MHIGh | MLOW
AUTO
The voltage range is set with CHANnel<ch>:SCALe.
MHIGh
Sets the higher voltage range of the connected probe. To query
the value, use PROBe<ch>:SETup:ATTenuation[:AUTO]?.
MLOW
Sets the lower voltage range of the connected probe. To query
the value, use PROBe<ch>:SETup:ATTenuation[:AUTO]?.
*RST: AUTO
Usage: Asynchronous command
Manual operation: See "Range" on page 135
PROBe<ch>:SETup:ADVanced:PMToffset
Sets the measured ProbeMeter value as offset. Thus, the value is considered in mea-
surements.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Usage: Setting only
Asynchronous command
Manual operation: See "ProbeMeter to offset" on page 134
17.8.8.3 Settings for modular probes
PROBe<ch>:SETup:PRMode..........................................................................................532
PROBe<ch>:SETup:CMOFfset........................................................................................532
PROBe<ch>:SETup:DMOFfset........................................................................................532
PROBe<ch>:SETup:NOFFset......................................................................................... 533
PROBe<ch>:SETup:POFFset..........................................................................................533
PROBe<ch>:SETup:TERM:ADJust.................................................................................. 533
PROBe<ch>:SETup:TERM:MEASure?.............................................................................534
PROBe<ch>:SETup:TERM:MODE...................................................................................534
PROBe<ch>:SETup:TERM:STATe................................................................................... 534
Acquisition and setup