Rohde & Schwarz MXO 4 Series - High Definition Mode

Remote control commandsMXO 4 Series
538User Manual 1335.5337.02 ─ 07
Return values:
<InputCapacity> Range: 1E-13 to 1E-07
Default unit: F
Usage: Query only
Asynchronous command
PROBe<ch>:SETup:IMPedance?
Queries the termination of the probe.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Return values:
<InputImpedance> Range: 0 to 1E+9
Default unit: Ω
Usage: Query only
Asynchronous command
17.8.9 High definition mode
HDEFinition:BWIDth.......................................................................................................538
HDEFinition:RESolution?................................................................................................ 538
HDEFinition:STATe.........................................................................................................539
HDEFinition:BWIDth <Bandwidth>
Sets the filter bandwidth for the high definition mode.
Parameters:
<Bandwidth> Range: 10000 to 2E+9
Increment: 1000
*RST: 100E+6
Default unit: Hz
Usage: Asynchronous command
Manual operation: See "Bandwidth" on page 117
HDEFinition:RESolution?
Displays the resulting vertical resolution in high definition mode. The higher the filter
bandwidth, the lower the resolution.
Return values:
<Resolution> Range: 0 to 18
Increment: 0.1
*RST: 0
Default unit: bit
Acquisition and setup