Rohde & Schwarz MXO 4 Series - Runt Trigger

Remote control commandsMXO 4 Series
549User Manual 1335.5337.02 ─ 07
TRIGger:EVENt<ev>:WIDTh:WIDTh <Width>
Depending on the values of TRIGger:EVENt<ev>:WIDTh:RANGe the width sets:
●
For the ranges Within and Outside, the width defines the center of a time range
which is defined by the limits "±Delta" (see TRIGger:EVENt<ev>:WIDTh:DELTa
).
●
For the ranges Shorter and Longer, it defines the maximum and minimum time
lapse, respectively.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Parameters:
<Width> Range: 1E-10 to 10000
Increment: 1E-07
*RST: 5E-09
Default unit: s
Usage: Asynchronous command
Manual operation: See "Width" on page 152
17.9.6 Runt trigger
TRIGger:EVENt<ev>:LEVel<n>:RUNT:LOWer.................................................................. 549
TRIGger:EVENt<ev>:LEVel<n>:RUNT:UPPer................................................................... 550
TRIGger:EVENt<ev>:RUNT:DELTa.................................................................................. 550
TRIGger:EVENt<ev>:RUNT:POLarity............................................................................... 550
TRIGger:EVENt<ev>:RUNT:RANGe................................................................................ 551
TRIGger:EVENt<ev>:RUNT:WIDTh................................................................................. 551
TRIGger:EVENt<ev>:LEVel<n>:RUNT:LOWer <Level>
Sets the lower voltage limit.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
<n> 1 to 4, index of the analog channel
Parameters:
<Level> Range: -10 to 10
Increment: 0.001
*RST: -0.1
Default unit: V
Usage: Asynchronous command
Manual operation: See "Lower level" on page 154
Trigger