Rohde & Schwarz MXO 4 Series - Page 586

Remote control commandsMXO 4 Series
586User Manual 1335.5337.02 ─ 07
Suffix:
<m>
.
1...5, index of the math waveform
Example:
CALC:MATH1:DATA:HEAD?
-9.477E-008,9.477E-008,200000,1
Usage: Query only
Asynchronous command
CALCulate:MATH<m>:DATA:STYPe?
Returns the signal type of the source of the math waveform.
Suffix:
<m>
.
1...5, index of the math waveform
Return values:
<SignalType> SOUR | CORR | MEAS | NONE
SOURce = normal signal
CORRelation = correlated signal, specific math signal
MEAsurement = result of a measurement
NONE = undefined
Usage: Query only
Asynchronous command
CALCulate:MATH<m>:DATA[:VALues]? [<Offset>[,<Length>]]
Returns the data of the math waveform points for transmission from the instrument to
the controlling computer. The data can be used in MATLAB, for example.
Without parameters, the complete waveform is retrieved. Using the offset and length
parameters, data can be retrieved in smaller portions, which makes the command
faster. If you send only one parameter, it is interpreted as offset, and the data is
retrieved from offset to the end of the waveform.
To set the export format, use FORMat[:DATA].
Suffix:
<m>
.
1...5, index of the math waveform
Query parameters:
<Offset> Number of offset waveform points to be skipped.
<Length> Number of waveform points to be retrieved.
Return values:
<Data> List of values according to the format and content settings.
Example:
:CALCulate:MATH1:DATA:VALues? 100,10
Returns 10 points from the start index 100.
Usage: Query only
Asynchronous command
Waveform analysis