Rohde & Schwarz MXO 4 Series - Page 593

Remote control commandsMXO 4 Series
593User Manual 1335.5337.02 ─ 07
Usage: Event
Asynchronous command
Manual operation: See "Create/update" on page 201
17.10.4.2 Scaling
REFCurve<rc>:AXIS[:XMODe]........................................................................................ 593
REFCurve<rc>:SCALe................................................................................................... 593
REFCurve<rc>:POSition.................................................................................................594
REFCurve<rc>:HMODe.................................................................................................. 594
REFCurve<rc>:RESCale:HORizontal:FACTor................................................................... 594
REFCurve<rc>:RESCale:HORizontal:OFFSet...................................................................595
REFCurve<rc>:RESCale:HORizontal:STATe.....................................................................595
REFCurve<rc>:RESCale:VERTical:FACTor.......................................................................595
REFCurve<rc>:RESCale:VERTical:OFFSet...................................................................... 596
REFCurve<rc>:RESCale:VERTical:STATe........................................................................ 596
REFCurve<rc>:TOORiginal.............................................................................................596
REFCurve<rc>:VMODe.................................................................................................. 597
REFCurve<rc>:AXIS[:XMODe] <XAxisMode>
Defines the scaling method for the frequency (x-axis) of the reference curve.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<XAxisMode> LIN | LOG
LIN: Linear scaling
LOG: Logarithmic scaling
*RST: LIN
Usage: Asynchronous command
REFCurve<rc>:SCALe <VerticalScale>
Sets the vertical scale, which defines the displayed amplitude of the selected wave-
form.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<VerticalScale> Range: 1E-15 to 1E+26
Increment: 1E-05
*RST: 0.5
Default unit: Unit of the source waveform
Usage: Asynchronous command
Manual operation: See "[Scale]" on page 43
Waveform analysis