Rohde & Schwarz MXO 4 Series - Page 594

Remote control commandsMXO 4 Series
594User Manual 1335.5337.02 ─ 07
REFCurve<rc>:POSition <VertPosi>
Available, if REFCurve<rc>:VMODe is set to INDependent.
Moves the reference waveform up or down in the diagram.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<VertPosi> Range: -1E+26 to 1E+26
Increment: 0.02
*RST: 0
Default unit: div
Usage: Asynchronous command
Manual operation: See "Vertical position" on page 204
REFCurve<rc>:HMODe
<HorizontalMode>
Selects the coupling of horizontal settings.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<HorizontalMode> ORIGinal | COUPled
ORIGinal
Horizontal scaling and reference point of the source waveform
are used.
COUPled
The current horizontal settings of the diagram are used.
*RST: ORIGinal
Usage: Asynchronous command
Manual operation: See "Mode" on page 206
REFCurve<rc>:RESCale:HORizontal:FACTor <ScaleFactor>
Sets the horizontal scale factor. A factor greater than 1 stretches the waveform hori-
zontally, a factor lower than 1 compresses the curve.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<ScaleFactor> Range: 1E-14 to 100000000000000
Increment: 0.1
*RST: 1
Usage: Asynchronous command
Manual operation: See "Scale factor" on page 206
Waveform analysis