Remote control commandsMXO 4 Series
595User Manual 1335.5337.02 ─ 07
REFCurve<rc>:RESCale:HORizontal:OFFSet <Offset>
Moves the waveform horizontally. Enter a value with a time unit suitable for the time
scale of the diagram.
Positive values shift the waveform to the right, negative values shift it to the left.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<Offset> Range: -5000000 to 5000000
Increment: 0.01
*RST: 0
Default unit: s
Usage: Asynchronous command
Manual operation: See "Horizontal offset" on page 206
REFCurve<rc>:RESCale:HORizontal:STATe
<State>
If enabled, the horizontal offset and factor are applied to the reference waveform.
Stretching and offset change the display of the waveform independent of the horizontal
settings of the source waveform and of the horizontal diagram settings.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Enable" on page 206
REFCurve<rc>:RESCale:VERTical:FACTor <ScaleFactor>
Sets the vertical scale factor. A factor greater than 1 stretches the waveform vertically,
a factor lower than 1 compresses the curve.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<ScaleFactor> Range: -100000000 to 100000000
Increment: 0.1
*RST: 1
Usage: Asynchronous command
Manual operation: See "Scale factor" on page 205
Waveform analysis
To Next Page
Loading...
