Rohde & Schwarz MXO 4 Series - Results

Remote control commandsMXO 4 Series
609User Manual 1335.5337.02 ─ 07
Manual operation: See "Export mode" on page 298
EXPort:WAVeform:GATE
Selects the gate to be used for limited data export if EXPort:WAVeform:SCOPe is set
to GATE.
Usage: Asynchronous command
Manual operation: See "Export mode" on page 298
EXPort:WAVeform:CURSorset <Cursorset>
Sets the cursor set to be used for limited data export if EXPort:WAVeform:SCOPe is
set to CURSor.
Parameters:
<Cursorset> CURSOR1 | CURSor1 | CURSOR2 | CURSor2
CURSORx = CURSorx
Usage: Asynchronous command
Manual operation: See "Export mode" on page 298
17.11.5 Results
EXPort:RESult:NAME.....................................................................................................609
EXPort:RESult:SAVE......................................................................................................609
EXPort:RESult:SELect:CURSor.......................................................................................610
EXPort:RESult:SELect:MEASurement..............................................................................610
EXPort:RESult:NAME <FilePath>
Sets the path, the filename and the file format of the export file.
Parameters:
<FilePath> String with path and file name with extension .csv.
Usage: Asynchronous command
EXPort:RESult:SAVE
Saves the results to file. The target file is set using EXPort:RESult:NAME. To select
the results to be exported, use EXPort:RESult:SELect:CURSor and EXPort:
RESult:SELect:MEASurement.
Usage:
Event
Asynchronous command
Data management