Operating the instrumentMXO 4 Series
64User Manual 1335.5337.02 ─ 07
2. Select the comb of the needed object, or object group.
3. If you have selected an object, the object gets the focus. Change its position
directly on the screen or with the [Multiuse] knob, or perform other actions depend-
ing on the selected object.
4. If you have selected an object group, the submenu opens.
The image shows the submenu of "Zoom Z1".
5. In the submenu, select the comb of the needed object.
6. Modify the selected object as required.
Using the selection menu
To Next Page
Loading...
