Rohde & Schwarz MXO 4 Series - Page 651

Remote control commandsMXO 4 Series
651User Manual 1335.5337.02 ─ 07
Suffix:
<sp>
.
1
Usage: Setting only
Asynchronous command
Manual operation: See "Spectrum preset" on page 250
CALCulate:SPECtrum<sp>:SOURce <Source>
Selects the source for the spectrum.
Suffix:
<sp>
.
1
Parameters:
<Source> C1 | C2 | C3 | C4 | M1 | M2 | M3 | M4 | M5 | R1 | R2 | R3 | R4
Usage: Asynchronous command
Manual operation: See "Source" on page 247
CALCulate:SPECtrum<sp>:STATe <State>
Enables the spectrum.
Suffix:
<sp>
.
1
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Display" on page 247
CALCulate:SPECtrum<sp>:THReshold <Threshold>
Sets an absolute threshold as an additional condition for the peak search. Only peaks
that exceed the threshold are detected.
Suffix:
<sp>
.
1
Parameters:
<Threshold> Range: -500 to 500
Increment: 1
*RST: -70
Default unit: dBm
Usage: Asynchronous command
Manual operation: See "Threshold" on page 216
Spectrum analysis