Rohde & Schwarz MXO 4 Series - Page 661

Remote control commandsMXO 4 Series
661User Manual 1335.5337.02 ─ 07
FRANalysis:REPeat....................................................................................................... 665
FRANalysis:RESet......................................................................................................... 665
FRANalysis:PHASe:MAXimum........................................................................................665
FRANalysis:STATe <Value>
Starts the frequency response analysis.
Parameters:
<Value> RUN | STOP
Usage: Asynchronous command
Manual operation: See "Run" on page 261
FRANalysis:ENABle <State>
Enables the frequency response analysis application.
If the frequency response analysis is disabled, the instrument does not accept any
FRANalysis command.
You can start the analysis with FRANalysis:STATe.
Parameters:
<State> ON | OFF
Usage: Asynchronous command
FRANalysis:AUToscale <AutoScale>
Enables the auto scaling function for each measurement.
Parameters:
<AutoScale> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Auto scale" on page 265
FRANalysis:AMPLitude:MODE <AmplitudeMode>
Selects, if the amplitude is a constant value (FRANalysis:GENerator:AMPLitude)
or is defined as an amplitude profile.
Parameters:
<AmplitudeMode> CONStant | PROFile
*RST: CONStant
Usage: Asynchronous command
Manual operation: See "Amplitude profile" on page 261
Applications