Rohde & Schwarz MXO 4 Series - Page 666

Remote control commandsMXO 4 Series
666User Manual 1335.5337.02 ─ 07
By default, the "Maximum phase" is set to 180° for a phase window ranging from -180°
to 180° accordingly.
Parameters:
<MaxPhase> Range: 0 to 360
Increment: 1
*RST: 180
Default unit: °
Usage: Asynchronous command
Manual operation: See "Maximum phase" on page 264
17.15.1.2
Frequency response analysis amplitude profile
FRANalysis:AMPLitude:PROFile:COUNt.......................................................................... 666
FRANalysis:AMPLitude:PROFile:APOint.......................................................................... 666
FRANalysis:AMPLitude:PROFile:POINt<m>:REMove........................................................666
FRANalysis:AMPLitude:PROFile:SORT............................................................................667
FRANalysis:AMPLitude:PROFile:MODE...........................................................................667
FRANalysis:AMPLitude:PROFile:POINt<m>:FREQuency...................................................667
FRANalysis:AMPLitude:PROFile:POINt<m>:AMPLitude.....................................................667
FRANalysis:AMPLitude:PROFile:COUNt <Value>
Returns the number of defined points for the amplitude profile.
Parameters:
<Value>
Usage: Asynchronous command
Manual operation: See "Step start freq, Amplitude" on page 262
FRANalysis:AMPLitude:PROFile:APOint
Adds a new point to the amplitude profile.
Usage:
Setting only
Asynchronous command
Manual operation: See "Add" on page 262
FRANalysis:AMPLitude:PROFile:POINt<m>:REMove
Removes the selected amplitude point from the list.
Suffix:
<m>
.
Index of the amplitude profile point
Usage: Setting only
Asynchronous command
Manual operation: See "Delete" on page 263
Applications