Rohde & Schwarz MXO 4 Series - Page 670

Remote control commandsMXO 4 Series
670User Manual 1335.5337.02 ─ 07
Parameters:
<VerticalOffset> Range: -2000 to 2000
Increment: 1
*RST: 10
Default unit: dB
Usage: Asynchronous command
FRANalysis:GAIN:SCALe <VerticalScale>
Sets the vertical scale for the gain waveform.
Parameters:
<VerticalScale> Range: 0.1 to 20
Increment: 1
*RST: 10
Default unit: dB/div
Usage: Asynchronous command
FRANalysis:AMPLitude:SCALe <VerticalScale>
Sets the vertical scale for the amplitude waveform.
Parameters:
<VerticalScale> Range: 0.01 to 10
Increment: 0.01
*RST: 0.5
Default unit: Vpp/div
Usage: Asynchronous command
FRANalysis:AMPLitude:ENABle <State>
Enables the amplitude signal for the frequency response analysis. You can then define
the amplitude profile of the signal.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Amplitude profile" on page 261
FRANalysis:AMPLitude:OFFSet <VerticalOffset>
Sets a vertical offset of the amplitude waveform.
Applications