Rohde & Schwarz MXO 4 Series - Page 672

Remote control commandsMXO 4 Series
672User Manual 1335.5337.02 ─ 07
Example:
FRAN:GAIN:DATA?
Result:
0.4381956630254851,0.4593246383252179,
0.461895233375762,0.4570717993766185,
0.4623802509651942,0.4533450898899926,
0.4408194360143725,0.4221600784741697,
0.4483342212879299,0.4473558449908476,
0.4915016244058707
Usage: Query only
Asynchronous command
17.15.1.5
Frequency response analysis results
FRANalysis:RESult:STATe.............................................................................................. 672
FRANalysis:MARGin:STATe............................................................................................ 672
FRANalysis:MARGin:GAIN:FREQuency?......................................................................... 673
FRANalysis:MARGin:GAIN:VALue?................................................................................. 673
FRANalysis:MARGin:PHASe:FREQuency?...................................................................... 673
FRANalysis:MARGin:PHASe:VALue?.............................................................................. 673
FRANalysis:MARKer<m>:STATe......................................................................................673
FRANalysis:MARKer<m>:FREQuency............................................................................. 674
FRANalysis:MARKer<m>:GAIN?..................................................................................... 674
FRANalysis:MARKer<m>:PHASe?.................................................................................. 674
FRANalysis:MARKer<m>:SSCReen................................................................................ 674
FRANalysis:RESult:STATe <Table>
Enables the display of the result table for the FRA.
Parameters:
<Table> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Result table" on page 265
FRANalysis:MARGin:STATe <Margins>
Enables the display of the margin table for the FRA.
Parameters:
<Margins> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Margin" on page 265
Applications