Rohde & Schwarz MXO 4 Series - Page 705

Remote control commandsMXO 4 Series
705User Manual 1335.5337.02 ─ 07
Parameters:
<ZoomCoupling> ON | OFF
*RST: OFF
Manual operation: See "Zoom coupling" on page 317
SBUS<m>:THReshold <ShwThresLines>
If enabled, the threshold lines are displayed in the diagram.
The label of the threshold line is set according to the signal that it is referring to, see
also Show threshold lines.
Suffix:
<m>
.
1..4
Parameters:
<ShwThresLines> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Show threshold lines" on page 314
SBUS<m>:SETReflevels
Executes the measurement of reference levels and sets the thresholds to the middle
reference level of the measured amplitude.
Suffix:
<m>
.
1..4
Usage: Event
Asynchronous command
17.16.1.2 Export results settings
SBUS<sb>:EXPResult:DETail......................................................................................... 705
SBUS<sb>:EXPResult:SAVE.......................................................................................... 706
SBUS<sb>:EXPResult:TIME........................................................................................... 706
SBUS<sb>:EXPResult:EXTension................................................................................... 706
SBUS<sb>:EXPResult:PATH...........................................................................................706
SBUS<sb>:EXPResult:DETail <IncludeDetails>
If enabled, includes the detailed results for all frames in the export result file.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<IncludeDetails> ON | OFF
*RST: ON
Protocols