Rohde & Schwarz MXO 4 Series - Page 715

Remote control commandsMXO 4 Series
715User Manual 1335.5337.02 ─ 07
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 326
SBUS<sb>:SPI:FILTer:RST
Resets the state of the selected frames and error types.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 326
SBUS<sb>:SPI:FILTer:ENABle <Enable>
Enables the filtering on SPI frames. Only the frames that match the selected filter con-
ditions are displayed.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Enable> ON | OFF
*RST: ON
Usage: Asynchronous command
SBUS<sb>:SPI:FILTer:BIT <Frame>,<Field>,<Bit>
SBUS<sb>:SPI:FILTer:FRAMe<fr>:FLD<fl>:BIT <BitState>
Sets the operator for the data pattern in the selected field of the selected frame.
Suffix:
<sb>
.
1...4, index of the serial bus
<fr> index of the frame
<fl> index of the field
Parameters:
<BitState> ONE | ZERO
*RST: ZERO
Usage: Asynchronous command
Manual operation: See "Edit" on page 326
Protocols