Rohde & Schwarz MXO 4 Series - Page 729

Remote control commandsMXO 4 Series
729User Manual 1335.5337.02 ─ 07
SBUS<sb>:I2C:NEWList <FileName>
Loads a symbol list file.
Suffix:
<sb>
.
1...4, index of the serial bus
Setting parameters:
<FileName> String parameter with path and file name.
Example:
SBUS1:I2C:NEWList
'/home/storage/userData/Protocol/I2C.csv'
SBUS1:I2C:SYMBols ON
Usage: Setting only
Asynchronous command
Manual operation: See "Show symbols" on page 340
17.16.3.2 Trigger
Trigger commands for serial buses affect the current trigger source. Therefore, set the
trigger source to the required serial bus with TRIGger:EVENt<ev>:SOURce before
sending the bus-specific trigger commands.
TRIGger:I2C:TYPE.........................................................................................................729
TRIGger:I2C:ACCess..................................................................................................... 730
TRIGger:I2C:ACONdition................................................................................................730
TRIGger:I2C:ADDRess...................................................................................................730
TRIGger:I2C:ADDTo.......................................................................................................731
TRIGger:I2C:ADNack..................................................................................................... 731
TRIGger:I2C:AMODe..................................................................................................... 731
TRIGger:I2C:DCONdition................................................................................................731
TRIGger:I2C:DMIN.........................................................................................................732
TRIGger:I2C:DPOSition..................................................................................................732
TRIGger:I2C:DRNack.....................................................................................................732
TRIGger:I2C:DWNack.................................................................................................... 732
TRIGger:I2C:TYPE <Type>
Selects the trigger type for I²C analysis.
Parameters:
<Type> STARt | REPStart | STOP | NACK | ADDRess | DATA | ADAT
STARt
Start condition
REPStart
Repeated start - the start condition occurs without previous stop
condition.
STOP
Stop condition, end of frame
Protocols