Rohde & Schwarz MXO 4 Series - Page 731

Remote control commandsMXO 4 Series
731User Manual 1335.5337.02 ─ 07
Usage: Asynchronous command
Manual operation: See "Address" on page 347
TRIGger:I2C:ADDTo <AddressTo>
Sets the end value of an address range if the condition is set to an address range with
TRIGger:I2C:ACONdition.
Parameters:
<AddressTo> List of comma-separated values
Usage: Asynchronous command
Manual operation: See "Address" on page 347
TRIGger:I2C:ADNack
<AddressNack>
Triggers if the address acknowledge bit is missing - no target recognizes the address.
Parameters:
<AddressNack> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "No Ack conditions" on page 347
TRIGger:I2C:AMODe <AddressType>
Sets the address length to be triggered on: 7 bit or 10 bit.
Parameters:
<AddressType> BIT7 | BIT10
*RST: BIT7
Usage: Asynchronous command
Manual operation: See "Address type" on page 347
TRIGger:I2C:DCONdition <DataOperator>
Sets the operator to set a specific data value or a data range.
Parameters:
<DataOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
*RST: EQUal
Usage: Asynchronous command
Manual operation: See "Data" on page 348
Protocols