Rohde & Schwarz MXO 4 Series - Page 770

Remote control commandsMXO 4 Series
770User Manual 1335.5337.02 ─ 07
TRIGger:CAN:FDATa:DPOSition <DataPosition>
Defines the number of the first data byte at which the data pattern may start.
Parameters:
<DataPosition> Range: 1 to 2048
Increment: 1
*RST: 1
Usage: Asynchronous command
TRIGger:CAN:DLC
<DLC>
Sets the data length code, the number of data bytes to be found. For complete defini-
tion, set also the operator with TRIGger:CAN:DLCCondition.
Parameters:
<DLC> Range: CAN: 1 to 8, CAN FD: 1 to 15 (64 bytes)
Increment: 1
*RST: 0
Usage: Asynchronous command
Manual operation: See "DLC" on page 382
TRIGger:CAN:DLCCondition <DLCOperator>
Operator to set the data length code.
The number of data bytes to be found is set with TRIGger:CAN:DLC.
Parameters:
<DLCOperator> EQUal | GETHan
For little endian transfer direction, EQUal must be set.
*RST: GETHan
Usage: Asynchronous command
Manual operation: See "DLC" on page 382
TRIGger:CAN:FTYPe <FrameType>
Sets the CAN frame type.
Parameters:
<FrameType> CBFF | CBFR | CEFF | CEFR | FBFF | FEFF | XLFF | ERRor |
OVERload
CBFF: classical base frame format data
CEFF: classical extended frame format data
FBFF: FD base frame format
FEFF: FD extended frame format
XLFF: XL frame format
Protocols