Rohde & Schwarz MXO 4 Series - Page 775

Remote control commandsMXO 4 Series
775User Manual 1335.5337.02 ─ 07
TRIGger:CAN:XDATa:AF:MIN <AfPattern>
Specifies an acceptance field pattern, or sets the start value of a range.
Parameters:
<AfPattern> List of comma separated values
Usage: Asynchronous command
Manual operation: See "AF" on page 384
TRIGger:CAN:XDATa:SDT:CONDition
<SdtOperator>
Sets the comparison condition for the service data unit type to a specific value or a
range.
Parameters:
<SdtOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, not equal, less than, less or equal than, greater than,
greater or equal than. These conditions require one pattern to be
set with TRIGger:CAN:XDATa:SDT:MIN.
INRange | OORange
In range / out of range: Set the minimum and maximum value of
the range with TRIGger:CAN:XDATa:SDT:MIN and TRIGger:
CAN:XDATa:SDT:MAX.
*RST: EQUal
Usage: Asynchronous command
Manual operation: See "SDT" on page 383
TRIGger:CAN:XDATa:SDT:MAX <SdtPatternTo>
Sets the end value of a service data unit type range if TRIGger:CAN:XDATa:SDT:
CONDition is set to INRange or OORange.
Parameters:
<SdtPatternTo> List of comma separated values
Usage: Asynchronous command
Manual operation: See "SDT" on page 383
TRIGger:CAN:XDATa:SDT:MIN <SdtPattern>
Specifies a service data unit type pattern, or sets the start value of a range.
Parameters:
<SdtPattern> List of comma separated values
Usage: Asynchronous command
Protocols