Rohde & Schwarz MXO 4 Series - Page 776

Remote control commandsMXO 4 Series
776User Manual 1335.5337.02 ─ 07
Manual operation: See "SDT" on page 383
TRIGger:CAN:XDATa:SEC <SEC_Bit>
Sets a value for the simple extended content (SEC) field. It indicates, if the CAN XL
data frame uses the CADsec protocol.
Parameters:
<SEC_Bit> ONE | ZERO | DC
*RST: DC
Usage: Asynchronous command
Manual operation: See "SEC" on page 384
TRIGger:CAN:XDATa:VCID:CONDition
<VcidOperator>
Sets the comparison condition for the VCID to a specific value or a range.
Parameters:
<VcidOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, not equal, less than, less or equal than, greater than,
greater or equal than. These conditions require one pattern to be
set with TRIGger:CAN:XDATa:VCID:MIN.
INRange | OORange
In range / out of range: Set the minimum and maximum value of
the range with TRIGger:CAN:XDATa:VCID:MIN and
TRIGger:CAN:XDATa:VCID:MAX.
*RST: EQUal
Usage: Asynchronous command
Manual operation: See "VCID" on page 384
TRIGger:CAN:XDATa:VCID:MAX <VcidPatternTo>
Sets the end value of a VCID range if TRIGger:CAN:XDATa:VCID:CONDition is
set to INRange or OORange.
Parameters:
<VcidPatternTo> List of comma separated values
Usage: Asynchronous command
Manual operation: See "VCID" on page 384
TRIGger:CAN:XDATa:VCID:MIN <VcidPattern>
Specifies a VCID pattern, or sets the start value of a range.
Protocols