Instrument setupMXO 4 Series
78User Manual 1335.5337.02 ā 07
The following settings are required for remote control of the instrument via a connected
computer.
Transfer data format
Selects the data format that is used for transmission of waveform data from the instru-
ment to the controlling computer.
Waveform data can be retrieved using the following commands:
ā
DIGital<m>:DATA[:VALues]?
"Ascii"
Data values are returned in ASCII format as a list of comma-separa-
ted values in floating point format.
"FLOAT"
Binary format. Up to 7 significant digits are stored. If there are more
than 7 digits, the number is rounded off.
"DOUBLE"
Binary format. Up to 15 significant digits of the numbers are stored.
"INT8/16/32"
Signed integer data with length 8/16/ 32 bit.
Remote command:
FORMat[:DATA] on page 483
Bit pattern format
Sets the format for all bit pattern queries.
Remote command:
FORMat:BPATtern on page 484
5.1.4 Localization settings
Access: "Menu" > "Settings" > "System" > "Localization".
System settings
To Next Page
Loading...
