Rohde & Schwarz MXO 4 Series - Page 802

Remote control commandsMXO 4 Series
802User Manual 1335.5337.02 ─ 07
SBUS<sb>:LIN:FILTer:FRAMe<fr>:ENABle.......................................................................805
SBUS<sb>:LIN:FILTer:IMAX............................................................................................805
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:IMAX..............................................................805
SBUS<sb>:LIN:FILTer:IMIN.............................................................................................805
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:IMIN...............................................................805
SBUS<sb>:LIN:FILTer:IOPerator......................................................................................806
SBUS<sb>:LIN:FILTer:FRAMe<fr>:FLD<fl>:IOPerator....................................................... 806
SBUS<sb>:LIN:FILTer:CHKall
Enables the filter for all available frames and error types.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 399
SBUS<sb>:LIN:FILTer:CLR
Disables the filter for all available frames and error types.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 399
SBUS<sb>:LIN:FILTer:INVert
Inverts the current state of the frame and error types: all frames and error types that
were enabled are disabled and vice versa.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Manual operation: See "Check all, Clear, Invert, Reset" on page 399
SBUS<sb>:LIN:FILTer:RST
Resets the state of the selected frames and error types.
Suffix:
<sb>
.
1...4, index of the serial bus
Usage: Setting only
Asynchronous command
Protocols