Rohde & Schwarz MXO 4 Series - SPMI (Option R&S MXO4-K550)

Remote control commandsMXO 4 Series
812User Manual 1335.5337.02 ─ 07
Return values:
<Protected identifer> Range: 0 to 255
Increment: 1
*RST: 0
Usage: Query only
Asynchronous command
17.16.7 SPMI (option R&S MXO4-K550)
Before MXO 4 can accept the specific bus commands, make sure that:
●
The decoding of the specified bus is enabled with SBUS<sb>[:STATe].
●
The bus is set to the correct type with SBUS<sb>:TYPE.
● Configuration.........................................................................................................812
● Filter...................................................................................................................... 816
● Decode results...................................................................................................... 822
17.16.7.1 Configuration
SBUS<sb>:SPMI:GIDValue.............................................................................................812
SBUS<sb>:SPMI:GSIDenable.........................................................................................813
SBUS<sb>:SPMI:GTCHenable........................................................................................813
SBUS<sb>:SPMI:GTWDith............................................................................................. 813
SBUS<sb>:SPMI:SCLK:HYSTeresis................................................................................ 814
SBUS<sb>:SPMI:SCLK:SOURce.................................................................................... 814
SBUS<sb>:SPMI:SCLK:THReshold.................................................................................814
SBUS<sb>:SPMI:SDATa:HYSTeresis...............................................................................814
SBUS<sb>:SPMI:SDATa:SOURce................................................................................... 815
SBUS<sb>:SPMI:SDATa:THReshold................................................................................815
SBUS<sb>:SPMI:POSition..............................................................................................815
SBUS<sb>:SPMI:SCALe................................................................................................ 815
SBUS<sb>:SPMI:GIDValue <GSID>
Sets a value for the group sub index. Available, if SBUS<sb>:SPMI:GSIDenable is
set to ON.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<GSID> Range: 0 to 15
Increment: 1
*RST: 0
Usage: Asynchronous command
Manual operation: See "Use GSID, GSID (hex)" on page 407
Protocols