Rohde & Schwarz MXO 4 Series - Page 828

Remote control commandsMXO 4 Series
828User Manual 1335.5337.02 ─ 07
SBUS<sb>:TNOS:THReshold:LOWer.............................................................................. 829
SBUS<sb>:TNOS:THReshold:UPPer...............................................................................829
SBUS<sb>:TNOS:NEWList.............................................................................................829
SBUS<sb>:TNOS:HYSTeresis <Hysteresis>
Sets a value for the hysteresis.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Hysteresis>
Usage: Asynchronous command
Manual operation: See "Threshold" on page 415
SBUS<sb>:TNOS:POSition <TENBTO position>
Sets the vertical position of the 10BASE-T1S signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<TENBTO position>
Usage: Asynchronous command
SBUS<sb>:TNOS:SCALe <TENBTO scale>
Set the vertical scale of the indicated 10BASE-T1S signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<TENBTO scale>
Usage: Asynchronous command
SBUS<sb>:TNOS:SOURce <Source>
Selects the source for the 10BASE-T1S protocol. Only analog channels can be used.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Source> <char_data> | C1 | C2 | C3 | C4
Usage: Asynchronous command
Manual operation: See "Source" on page 414
Protocols